PTC University LEARN Questions

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Sweep Feature | Tutorial | PTC Learning Connector   at 0:53, the user clicks on "Sketch View" but then flips the model over. How do they flip the model over?

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Hello,the video demonstration in English of this exercise doesn't work even if I use Chrome explorer.BRFrank

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned. 

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Reply to this post to ask for help or to share what you have learned in this course.

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Hi, why cant i get the origin of the sweet to define at the end of the sweet, it identifies it as a chain not an constant line

Hello, It appears I dont have any of the training models available or I cant find them. Please help. 

Hello, My drive does not have the files that the exercises lists (currently on ex 1). I don't even have a PTCU folder, just a PTC. 

Hello, There is no "Submit Change Request" Task for the Front Housing Screw Clearance Change Request.  Please advise.  Note I can see the CR that I edited in Task 2 in Updates, just no Task to Submit it. Thanks,~patrick

I cannot add a dimension from the top of the part on the belt sander sketch. I hit the dimension but and click the two lines, but I do not get a dimension to appear. Can someone help? What am I doing wrong?I cannot get the to 25 dim in the tutorial for some reason, See the snip for reference.

Hello! I am in the middle of the Solid Modeling 2 course and the second exercise asks for a blend of three composite curves. My start points aren't aligning, and the guide recommends that they do but doesn't specify how to do that. I tried going into the sketch to manually select the start point, but since it's a referenced curve that doesn't appear to work. Any ideas on how to fix this?

The Practice section outlines assembling a bunch of stuff that was supposedly made in other modules, but where are those items?  I can go to those folders, but they only contain the files for those classes, and they do not correlate to the items I am supposed to assemble? i.e. Air Circulator needs built, but Class files are for Belt Sander

I cannot get the shell feature to work on the extended plenum.  It fails no matter what settings i put in AND Creo locks up for a good long while after I select the rounds to exclude.  The excercise asked for the rounds to be added first, so I assume it was focing that issue.  I also initially left the main housing unshelled, but when this issue arose,  I shelled it seperately in insert mode and it worked FINE.  I tried both single surface removal and both ends like I want.  I am including the model with the failed feature as reference.  Any help is appreciated.