Question regarding PF6000 and how KepwareOPC sets the JOB_JOBNUM value. Hello again, I have a question regarding how Kepware, using OpenProtocol handles the Job Info commandset. I have been told by an AtlasCopco representative, that before sending a Job Number via the message "Select Job" (MID38) to the PF6000 device, I must send a seperate message: MID30 "Job Number upload request". 0030Job numbers upload requestOpen, FEP Based on the documentation available to me, I can see that the Job Number Data command set uses MID30, then use MID31 to request information.However, because the values in the Job Number Data commandset are Read-Only, I do not think I can explicitly send this UploadRequest(MID30) before setting the JOB_JOBNUM value. (MID38) As such, I would appreciate the following information.Does setting the JOB_JOBNUM value via KepwareOPC, automatically send a upload request message (MID30), then the Select Job(MID38) message to the device?If setting the JOB_JOBNUM does not automatically send a upload request message, h
